Scarlett SC-WM4000, Инструкция по эксплуатации

Страница: 6 / 13

Fat and oil Put the dirty place face down on the fabric absorbing moisture and
process the spot on the inside. Clean the spot with a sponge
soaked with solvent or with liquid for dry cleaning. Wash as
usually.
Rust Process the spot with a lemon juice and salt and put the spot
under the sun. Wash as usually.
Mould Wash in warm water with a detergent. Process the spot with a
lemon juice, dry under the sun and wash as usually.
Dirt Clean the dry dirt with a brush. Rinse in cool water. If the spot sill
exist, rub a soap-powder in the spot and wash as usually.
Lip stick Clean the spot with denaturant alcohol and wash as usually.
Fruit spots Clean as soon as possible with a sponge soaked with cool water,
rub a soap-powder in the spot and wash as usually.
Iron scorch Soak a napkin with hydrogen peroxide, put in on the scorch spots
and iron.
MAINTENANCE AND CARE
·
Cleaning after use will extend your washing machine. Before cleaning turn off the power
switch and disconnect the power cord from the electrical outlet.
·
Check that both timers are set to the position.
·
Wipe off spillage from wash powder, etc. and generally wipe over the tub and base with a
clean damp cloth.
·
When the washing machine is dirty, please wipe it with a wet soft cloth. Do not wipe it with
gasoline and alcohol. Do not scour it with water directly.
·
Remove the hose from the water tap.
·
Keep the washing machine in a shady and cool well ventilated place.
Filter cleaning
·
Remove the lint filter by pulling it forward.
·
Wash away the lint stuck in the filter during overflowing.
·
Reinstall the filter by first inserting its bottom section and then pushing the upper part firmly
into place.
TROUBLESHOOTING
Before calling for a service engineer, please check the following points.
If your washing machine dose not start, check whether:
·
The house circuit breaker is tripped or a fuse is blown.
·
The cord is firmly connected to the power point or the power point is not switched on.
·
Something is preventing the pulsator from rotating.
·
The wash timer is set.
If the spin dryer dose not operate, check whether:
·
The inner lid and outer spin bowl-lids are closed.
·
The spin dry timer is set.
If there is excessive noise, check whether:
·
Something is touching the pulsator as it rotates.
·
The machine is placed on a level surface.
·
The wash load in the spin bowl is excessively unbalanced during the spin cycle.
·
An article lodged between the spin bowl and tub.