Scarlett SC-SI30K14, Инструкция по эксплуатации

Страница: 4 / 30

IM013
www.scarlett.ru SC-SI30K14 4
GB INSTRUCTION MANUAL
IMPORTANT SAFEGUARDS
•
Please read the instruction manual before use and save it for future references.
•
Before the first switching on check that voltage indicated on the rating label corresponds to the mains voltage in
your home.
•
For home use only. Do not use for industrial purposes. Use the steam iron only for its intended use.
•
Do not use outdoors or in damp area.
•
Do not immerse the steam iron and cord in water or other liquids.
•
Never pull the cord while disconnecting from the power outlet; instead, grasp the plug only and pull to disconnect.
•
Do not allow the cord to touch sharp edges and hot surfaces.
•
Always unplug the steam iron from the power supply when filling with water or emptying and when not in use.
•
Do not operate the steam iron with damaged cord or plug, or after the appliance malfunctions, or has been
dropped or damaged in any manner. To avoid risk of electric shock, do not disassemble the steam iron; take it to
a service center for examination, repair or mechanical adjustment.
•
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
concerning use of the appliances by a person responsible for their safety.
•
Do not attempt to repair, adjust or replace any parts of the appliance. Check and repair the malfunctioning
appliance in the nearest service center only.
•
Children should be supervised to ensure that they do not play with the appliance.
•
Do not leave the iron unattended while hot or connected or on an ironing board.
•
If ironing is interrupted, stand the iron on heel rest only, do not place the steam iron on metal or rough surfaces.
•
CAUTION: To avoid a circuit overload, do not operate another high wattage appliance on the same circuit.
•
If the product has been exposed to temperatures below 0ºC for some time it should be kept at room temperature
for at least 2 hours before turning it on.
•
The manufacturer reserves the right to introduce minor changes into the product design without prior notice,
unless such changes influence significantly the product safety, performance, and functions.
IRON SOLEPLATE
•
The "Keramopro" soleplates are coated with the professional metal-ceramic coating developed in collaboration
with Scarlett specialists. The coating is characterized by an enhanced level of strength, glide and 100%
resistance to burning.
BEFORE THE FIRST USE
•
Some parts of the steam iron have been slightly greased and as a result the iron may slightly smoke when
switched on for the first time. After a short time this will cease.
•
Remove protection cover from the soleplate and clean it with a soft cloth.
HOW TO USE
SETTING TEMPERATURE
•
Always check whether a label with ironing instructions is attached to an article to be ironed. Follow these
instructions in all cases.
•
Turn the temperature control dial round to set the appropriate temperature indicated in ironing instructions or on
fabric label.
LABEL TYPE OF TEXTILE
Do not iron this article
• Synthetics, Nylon, Acrylics, Polyester, Rayon
•• Wool, Silk
••• Cotton, Linen
Maximum temperature (Steam)
ECO For all types of textile except synthetic fabric
•
Insert the mains plug into the wall socket. The indicator light will turn on.
•
When the indicator light goes out you may start ironing
•
If you set the temperature control to lower setting after ironing at a high temperature, it is not recommended to
iron before the pilot light switches on again.
WATER TANK FILLING
•
Unplug the iron before filling the water tank.
•
Hold the steam iron in horizontal position.
•
Slowly pour water through the water inlet.
•
Do not fill higher than mark on the water tank, in order to avoid water spilling.
•
The opening which is used for pouring water should be closed when the iron is in use.
•
Always unplug the iron from the power socket when refilling the water reservoir.
NOTE: Your steam iron is designed to use tap water. However, if the water is very hard, it is advisable to use
distilled water.
NOTE: Do not use chemically de-limed or perfumed water.
NOTE: If you have too hard water,it is advisable to use only distilled or demineralized water.