3
ASSEMBLING
·
First put the unit upside down.
·
Install multidirectional rolling wheels to each end
between the first and the second groups of the
radiating flanges.
·
Let the
shape screw surrounding the dome of the
radiating flanges. Then insert it into two holes of the
supporting plate.
·
Insert the butterfly nuts and screw them tightly counter
clockwise.
USING THE APPLIANCE
·
Set the thermostat to the minimal position and power switch knob to the
position, insert
the plug to the power supply.
POWER SWITCH KNOB
·
You can adjust power of work of an oil heater, using power switch knob:
-
O
Off;
-
minimal power;
-
II
medium power;
-
III
maximal power.
THERMOSTAT
·
Set the power switch knob to III position thus the pilot light should light up.
·
Set the thermostat to the maximum position.
·
When the temperature rises to which you are satisfied with, slowly turn the thermostat
counterclockwise until the pilot light is out, and the room temperature thus can keep
constant.
·
If you want to change the room temperature, you can make another regulation: turn the
thermostat clockwise to rise the temperature and counterclockwise to lower it, or turn the
power switch knob to the or II position.
·
The pilot light will be on only if the temperature is below the setting value of the thermostat.
NOTES:
·
The room must be sealed in good condition, if not, it will not make good result because of
the influx of heat.
·
After use, turn the power switch knob to the
position and turn the thermostat to the
minimal position and unplug from power supply.
MODEL
POWER REGULATION
RANGE (W)
SUITABLE FOR AREA
(m²)
SC-1152
600/900/1500
15
SC-1153
800/1200/2000
18
SC-1154
1000/1300/2300
23
