Scarlett SC-053 Скачать руководство пользователя

Страница: 3 / 12

www.scarlett-europe.com

SC-053/054

INSTRUCTION MANUAL

IMPORTANT SAFEGUARDS

Please read all instruction manuals before use and save it for future references.

Before first switching on check that voltage indicated on the rating label corresponds the mains voltage in your home.

For home use only. Do not use for industrial purposes. Use the appliance only for its intended use.

Do not use outdoors or in damp area.

Do not immerse the appliance and cord in water or other liquids.

Never pull the cord while disconnecting from the power outlet; instead, grasp the plug only and pull to disconnect.

Do not allow the cord to touch sharp edges and hot surfaces.

Always unplug appliance from the power supply when not in use.

Do not operate the appliance with damaged cord or plug, or after the appliance malfunctions, or has been dropped or damaged in any manner. To
avoid the risk of electric shock, do not disassemble the appliance; take it to a service center for examination, repair or mechanical adjustment.

Close supervision is necessary when the appliance is used near children.

Do not leave appliance unattended while operating.

The oil heater must be used only in the upright position.

Unit surface temperature of the appliance is high, thus do not touch it, except the handle.

Operating unit should be far away from the flammable or easy bulging under high temperature objects.

CAUTION:

To avoid a circuit overload, do not operate another high wattage appliance on the same circuit.

Do not cover the appliance when in use.

ASSEMBLING

First turn the unit upside-down.

Install multidirectional rolling wheels to each end between the first and the second groups of the heating
flanges.

Let the

shape screw surround the dome of the heating flanges. Then insert it into two holes of the

supporting plate.

Use butterfly nuts to screw them tightly counterclockwise.

Place heater normally and make sure that it is inconvertible.

USING THE APPLIANCE

Set thermostat to and power switch to minimal position, plug in the appliance.

POWER SELECTOR

You can adjust oil heater current power using power regulator:

Off;

Minimal power;

Medium power;

simultaneously Maximum power;

THERMOSTAT

Set thermostat to maximum position.

When the temperature rises to satisfying level, slowly turn the thermostat counterclockwise until the indicator lights is out, and the room temperature
thus can keep constant.

If you want to change the room temperature, you can make another regulation: turn the thermostat clockwise to arise the temperature and
counterclockwise to lower it.

When the temperature is below than thermostat set value, heating element will switch on and corresponding indicator will light (or both indicators if
maximum power was set).

FAN CONTROL

This appliance is equipped with built-in fan for stimulating warm air convection. To activate this fan, simply press the fan switch.

NOTES:

The room must be properly sealed, if not, using of oil heater will not make good result because of heat leakage.

After use, turn the power selector to the

position, then turn the thermostat to minimum position and unplug from power supply.

CLEAN AND CARE

The oil heater should be cleaned regularly to wipe out the dust on the surface of fins. As this may result the radiating efficient.

Unplug from the power supply and allow the appliance to cool down.

Wipe out with a soft damp cloth. Do not use detergent or abrasives.

Do not scrap the surfaces of fins with sharp hard tools, to avoid surfaces getting rusty, because of damage of the paint coat.

STORAGE