Scarlett comfort SC-SF111B18, Инструкция по эксплуатации

Страница: 8 / 8

IM020
SC-SF111B18 8

Do not attempt to repair, adjust or replace parts in the appliance. Repair the malfunctioning appliance in the
nearest service center.

If the product has been exposed to temperatures below 0ºC for some time it should be kept at room temperature
for at least 2 hours before turning it on.

The manufacturer reserves the right to introduce minor changes into the product design without prior notice, unless
such changes influence significantly the product safety, performance, and functions.

Manufacturing date is indicated on the unit and/or on packing as well as in accompanying documents in the
following format XX.XXXX where first two figures XX is the month of production, and following four figures XXXX is
the year of production.
ASSEMBLING INSTRUCTIONS:

The device is intended for air circulation in the room.

Fan is packed disassembled. Before assembling make sure that all the required parts are undamaged and
included into the set.

Do not plug in the device before its assembling is finished.

Tighten stand tube to stand base with screw. Fix base cover to stand base with a screw (supplied with a set).

Unscrew out-joint, put the stand cover and base cover on the stand base, pull the extension pole out then tighten
the out-joint again.

Place control box firmly on top of extension pole, tighten screw B.

Unscrew the blade cap by turning clockwise and rear grill nut by turning counter clockwise and put both blade cap
and rear grill nut off the motor shaft.

Put rear grille on motor shaft.

Secure it with rear grille nut.

Slide blades on motor shaft so that claws on motor shaft match the blades slots.

Screw blade cap on shaft by turning counter clockwise.

Put front grille on rear grille and close clips or screw grille ring to secure grilles together.

Adjust the fan vertically by vertical adjustment screw.

The fan is ready for work.
OPERATION MANUAL

CAUTION: To avoid electroconvulsive shock or fire danger, do not operate fan under the conditions of increased
humidity.

Place fan only onto dry flat unyielding surface.

Turn the timer to the «ON» position and select the speed. The fan has three speed modes:
- "1" - the minimum fan speed;
- "2" - the average speed of rotation;
- "3" - the maximum speed of rotation;
- "0" - the fan is off.

On the upper part of the motor cover there is oscillating knob. If pressed, it makes the fan cabinet with blades
traverse from side to side. To cancel oscillating mode push oscillating knob upward.

Set the time.
TIMER
ATTENTION! The timer work only when you press one of the speed modes (1-3).

The timer is used to set the time of working of fan. The maximum working time is 2 hours.

To activate the timer, set the speed from 1 to 3.

To set the time, set the knob opposite the mark on the scale required timer.

To switc
h the fan off push the button “OFF”
MAINTENANCE

Before cleaning unplug fan first.

Clean front and rear grilles, blades, stand tube and stand base with soft moistened cloth and wipe dry.

Do not use abrasive cleansers
STORAGE

Keep the device in normal conditions in dry place.
The symbol on the unit, packing materials and/or documentations means used electrical and electronic units
and battery’s should not be toss in the garbage with ordinary household garbage. These units should be pass to
special receiving point.
For additional information about actual system of the garbage collection address to the local authority.
Valid utilization will help to save valuable resources and avoid negative work on the public health and environment
which happens with incorrect using garbage.