Scarlett COMFORT SC-DF111S07, Инструкция по эксплуатации, Страница: 8 / 9

IM020
SC-DF111S07 8

Do not place the appliance near heat sources.

Do not leave the switched on appliance unsupervised.

Do not use other attachments than those supplied with the appliance.

In case of power cord is damaged, its replacement should be done by the manufacture or service
department or the other high-skill person to avoid any danger.

Ensure that the cord does not hang over sharp edges and keep it away from hot surfaces.

To disconnect the appliance from the power supply pull it out by the plug only, not by the cord.

Avoid contact with moving parts of the device. Do not put pencils or other objects through the protective grid
of the fan.

Do not switch on the fan without well-adjusted front and rear grilles.

Do not attempt to repair, adjust or replace parts in the appliance. Repair the malfunctioning appliance in the
nearest service center.

If the product has been exposed to temperatures below 0ºC for some time it should be kept at room
temperature for at least 2 hours before turning it on

The manufacturer reserves the right to introduce minor changes into the product design without prior notice,
unless such changes influence significantly the product safety, performance, and functions.

Manufacturing date is indicated on the unit and/or on packing as well as in accompanying documents in the
following format XX.XXXX where first two figures XX is the month of production, and following four figures
XXXX is the year of production.
ASSEMBLING INSTRUCTIONS

The device is intended for air circulation in the room.

Place fan basement onto flat horizontal surface. Tighten stand tube to stand base moving it upward and
downward and fix it with screws.

Unscrew the blade cap by turning clockwise and rear guard mounting nut by turning counter clockwise. Put
rear grille on motor shaft so that two claws on motor cover match two holes on grille and secure with guard
nut.

Slide blades on motor shaft so that claws on motor shaft match the blades slots. Screw blade cap on shaft
by turning counter clockwise, otherwise the fan will sound abnormal and may be broken while operate.

Put front grill on rear grille and close clips or screw grill ring to secure grilles together.
CAUTION: Do not plug in the device before its assembling is finished.

Do not operate the appliance with damaged blades.
OPERATION MANUAL

CAUTION: To avoid electroconvulsive shock or fire danger, do not operate fan under the conditions of
increased humidity
for example do not use it outdoors when it’s raining.

Place fan only onto dry flat unyielding surface.
FAN OPERATING MODES

Switch the fan on by pushing any of the buttons:

1-For minimum operational speed

2-For medium operational speed

3-For maximum operational speed

To switch the fan off push the button “0”
OSCILLATING MODE (pic. 1)

On the upper part of the motor cover there is oscillating knob. If pressed, it makes the fan cabinet with
blades traverse from side to side with the angle 90
o
. To cancel oscillating mode push oscillating knob
upward.
VERTICAL ADJUSTMENT(pic.2.)

Air flow direction can be changed by adjusting fan control box in a higher or lower position by a vertical
adjustment screw.
MAINTENANCE

Before cleaning unplug fan first. Do not use abrasive cleansers, gasoline, solvents or other aggressive
detergents

Unfix clips on grille or unscrew grille ring and take off front grille. Clean the fan and blades with soft cloth
moistened with soap solution.
STORAGE

Keep the device in dry cool place.
It is recommended to keep and to use for seasonal storage the original carton box of the appliance.
The symbol on the unit, packing materials and/or documentations means used electrical and electronic
units and battery’s should not be toss in the garbage with ordinary household garbage. These units should
be pass to special receiving point.
For additional information about actual system of the garbage collection address to the local authority.