496256 Issue 1
17
4. Special Functions
4.
Press Enter.
The display shows (for example):
HALL
Z02: ZONE NOT OMITTED
5.
Press A or B until the display shows the zone that you want to omit.
Note that some zones may not be programmed for omission.
Note: You can also key in the zone number of the zone you want to omit. For
example, key in '005' for zone 5, or '025' for zone 25.
6.
Press C or D until the display shows the words "IS OMITTED".
7.
Press Enter.
The displays shows:
AREA READY
LEAVE
The system carries on to set as normal. The system will not raise an
alarm if the omitted zone is triggered. Note that the next time you set the
Level the system will treat the zone as normal; omission only lasts for
one setting/unsetting cycle.
Omitting 24 Hour Zones (Menu 2)
If your system is fitted with 24 hour detector zones, you may be able to omit
them if necessary. For example, your premises may have a fire door that you
occasionally open. Ask your Installer if this is possible.
If your system is programmed to allow you to omit a 24 hour zone, then:
1.
Key in your access code.
2.
Press
Menu
followed by
2
.
The display shows:
2: OMIT 24 HOUR
ZONES?
3.
Press Enter.
The displays shows (for example):
FIRE DOOR
Z16: NOT OMITTED
4.
Press A or B until the display shows the 24 hour
zone that you want to omit. Note that some zones
may not be programmed for omission.
5.
Press C or D until the display shows the words "IS OMITTED".
6.
Press Enter to store the change.
The displays shows:
2: OMIT 24 HOUR
ZONES?
7.
Press Menu if you wish to stop programming the system.
The system will not raise an alarm if the omitted zone is triggered.
