760ES
PAK200474_01E August 2008
Page 4 of 4
becomes fully active when you leave installer mode and depending on configuration may
sound when a tamper switch is activated.
Physical Installation
Attach the siren to a solid non-metallic wall using
suitable screws and wall fixing plugs. The fixing
points are located in the four corners of the
backplate.
To assist with levelling the siren there is a spirit
level in the upper part (Item 8 on diagram).
Fit rear tamper extender (if required) and trim to
desired length (see below).
Maintenance
Test the sounder and strobe periodically for correct operation . During routine
maintenance check the correct operation of cover and rear tampers. Check for signs of
significant water or insect ingress and clean as necessary. Replace batteries every two
years or when advised by the control unit.
Fault finding and diagnostics
The siren informs the control unit if its batteries have low voltage. The siren continues to
self-actuate under tamper conditions even when radio communications to the control unit
have been lost because of low battery voltage.
After installing, the siren will not sound until the control unit has left installer mode.
Changes in the environment (or deliberate jamming) may prevent radio transmission
between the siren and control unit. The siren will try to inform the control unit when
jamming is detected only if this feature is enabled using the configuration link.
The packaging supplied with this product may be recycled.
Please dispose of packaging accordingly.
Cooper Security Ltd
Security House
Vantage Point Business Village
Mitcheldean
Gloucestershire
GL17 0SZ
www.coopersecurity.co.uk
Product Support (UK) Tel: +44 (0) 1594 541979.
Available between:
08:15 and 17:00 Monday to Friday.Product Support Fax: (01594) 545401