5
2.2 Mounting of Centerless grinding attachment
See fig. 2.3 below.
1. Mount the new aluminium drive wheel with hard rubber surface (D) on the motor.
2. Fit the grinding belt.
3. Mount the blue side plate without tightening the bolts completely.
4. Mount the black top cover (A) on the hinge pivot of the blue side plate. Adjust the
side plate so the black top cover can be mounted on the hinge pivots. The blue top
rest where the eye shield is fitted onto must at the same time be adjusted so there
is a max. 5 mm/0.2 inch air gap between the blue top rest and the black top cover
(can be pushed forward and backwards).
5. Mount the cover with nylon surface (G) on top of the motor by doing the following:
a. Hold the cover down onto the motor so the surface is below the edge of the
side plate.
b. In order to mount the cover it is necessary to drill 2 holes ø2mm on each
side of the motor in the motor ribs.
c. Use the holes in the cover as guideline for drilling the ø2mm holes in the
motor ribs.
d. Use the 4 taptite screws and mount the cover.
6. Mount the Centerless Grinding Attachment (B) to the motor plate of the belt grinder
with 2 pcs. Bolts M10x25. must be adjusted so there is max. 5mm /0,2 inch air
between Centerless grinding attachment and the black top cover.
7. Mount the fan cover (J) for the motor again but this time only with 2 screws.
8. Mount the support table (I) underneath the machine section of the belt grinder.
9. Mount the dust extraction hose if the machine has dust extraction.
10. Mount the cover for exhaust pivot (H) on the belt grinder if the machine has an
exhaust system
11. Connect power to the Centerless grinding attachment by use of CE-plug.
