Scantech Vega V-1010, Руководство пользователя, Страница: 21 / 121

Scantech-ID VEGA Linear Imager 17
4.3 V-1010BT SET UP BLUETOOTH COMMUNICATION
Before the VEGA scanner can be used for normal operation, Bluetooth
communication must be set up between the VEGA scanner and cradle,
Scanner client mode or to a Bluetooth application device, Scanner Server
mode.
4.3.1
Pairing
Pairing refers to when a VEGA scanner has been linked or paired to a
specific cradle by scanning that cradle’s Bluetooth MAC address code, this
Bluetooth MAC address code is unique for each cradle. This address code is
located on the bottom side of the cradle. The pairing of a
VEGA scanner to a
cradle is one to one. Only one VEGA scanner can be paired to a cradle at
any point in time.
4.3.2
Set up Client Mode Communication
To set-up the communication between the VEGA scanner and the cradle
follow the next steps:
1. The VEGA scanner must scan “Scanner Client Mode ON/Scanner
Server Mode Off” barcode, to set the VEGA scanner in client mode.
2. Scan the Bluetooth MAC address code located on the bottom of the
cradle.
3. When the Bluetooth MAC was successfully scanned, scanner will
initiate with short beep sounds. Blue and red led will also blink
followed by a long beep sound.
4. Wait approximately five seconds, for completing the connection
process. Blue led will slow flash on scanner for connected the
cradle.
5. If successful, the blue led on the cradle will be on.
6. If the connections failed the scanner indicates with shot beep sounds
and the cradle with blinking blue led.