Scanstrut Ltd. 1 Malt Mill, Totnes, Devon, UK TQ9 5NH
Tel:
+44(0)1803 863800
Fax:
+44(0)1803 862223
e-mail:
website:
www.scanstrut.com
Composite PowerTower - PT2002/3/5/6
Installation Instructions
PowerTower kit contents
•
PowerTower
•
Base Seal
•
4 x Nylon Shouldered Washers
•
IP67 Cable Grommet
Also Required:
•
4 x M8 Stainless Steel bolts, large washers and nuts to attach PowerTower to
deck/arch. Length to suit deck/arch thickness.
•
Ø8.5mm Drill.
•
Hole Cutter for cable loom; approx Ø50mm dia.
Drilling for the antenna.
1. If installing PT2002/5, attach the PowerTower antenna template to the top of the
top plate of PowerTower. Mark through the centre of the holes for the antenna you
are to mount.
IMPORTANT:
[A] If you are installing a PT2003/6 please refer to the hole fixing
templates supplied with your antenna.
2. Drill a pilot hole (about 2mm dia.) through the top of PowerTower.
3. Turn over PowerTower and, from the underne ath of the top plate; open out the
holes to the required diameter.
Fitting PowerTower to the boat.
1. Attach PowerTower to the boat using 8mm (5/16 in) bolts, nuts and washers.
Self-locking or Nyloc nuts are recommended. Fit the white seal under the base of the
PowerTower.
2. Attach the antenna to the top of PowerTower using the bolts provided with the
antenna.
3. Install the cable using the waterproof grommet supplied. To fit the cable: Push
cable through hole in grommet to its chosen point and pull back until the internal
part of the grommet reverses back.
Note:
PT2003, PT2006 ARE NOT SUPPLIED WITH GROMMETS. Mini M and Gyro GPS
antennas usually have cables coming out of the base and will enter the top of the
PowerTower seals or grommets for this are normally supplied by the antenna
manufacturer.
www.busse-yachtshop.de | [email protected]
