4
SET UP & CONNECTION
Mains Connection
1. Connect the AC power cord to the unit via the AC socket at the back.
2. Plug the AC power cord to the AC mains outlet.
Network Connection
Wired network
1. Check first of all whether the control lamps (LINK/ACT) of your LAN connection or your router light up.
2. Use an Ethernet cable with RJ45 connector to connect the NETWORK socket of the radio with the LAN port of your
router.
3. Proceed for the operation as described in the below “GETTING STARTED”. But no need to run through the setup
wizard.
Note: Information on the LAN connection can be obtained from the user manual of the router manufacturer.
Wireless network
1. Check first of all whether the control lamps (LINK/ACT) of your WLAN connection or your router light up.
2. Proceed for the operation as described in the below “GETTING STARTED”. It is highly recommended to run through
the setup wizard in the system settings section.
Note: Information on the WLAN/WiFi network connection can be obtained from the user manual of the router manufacturer.
Walls or other obstacles may influence the WiFi range. Try to find the best location to avoid interruption and
interference while operating.
GETTING STARTED
Press the “ ” button once to switch on the radio, the display will show the main menu. To go to a function or open a sub-
menu, rotate the
SCROLL
control followed by pressing on it to confirm. Each function is selected via a menu consisting of
several levels.
Main menu
The following modes can be selected in the main menu:
Internet radio, Music player, FM radio, AUX in, Sleep, Alarms, System settings.
To select your desired function, rotate the
SCROLL
control followed by pressing on it to confirm.
System settings
Set up wizard
The setup wizard is available in the system settings section, you can run through this to configure settings for date/time
and network, once this has finished, your radio is ready to use.
Note: No need to run through the setup wizard if a wired network is used.
◊ 2/24 hour display
To select your preference between 12 and 24 hour clock display format - rotate the SCROLL control followed by pressing
on it to confirm.
◊ Time/Date
The time and date can be manually set or automatically via the network or FM.
Auto update
The auto update works with data sent over FM or the Internet. The clock is only updated when in a corresponding mode,
so it is recommended to select a mode that you use regularly.
1. Select auto update from FM or Network.
2. Select the appropriate time zone if the auto update is done by the Internet.
3. If your country uses daylight saving, the automatically update time may be wrong by one hour. Set the daylight savings
to ON when daylight savings are in effect.
Manual set
1. If “No update” is selected, the wizard will prompt you to set the time and date
manually. The date and time are displayed in dd-mm-yyyy and hh:mm AM/PM
format.
2. The value to be set will flash, rotate the
SCROLL
control to adjust the value
followed by pressing on it to go for the next setting, first set the date then finally
the time.
Downloaded from www.vandenborre.be
