3
Function Setting & Management application
：
Function Setting & Management application
：
This device could use command line to control via built in RS485 terminal program, (CLI
，
Command-Line Interface), through RS485 terminal port (Console Port) for detailed function
setup and management. You could use our model number: RS003 USB to RS485 converter, or
RS001 RS232 to RS485 converter, the Communication format is 9600,8, N, 1 (9600 bps, 1 start
bit, 8 data bits, 1 stop bit).
Use command as below
：
?
Display command usage
* n
Control device number (Device No), n = 0-32, Without input parameter: Display the device
number
Once the setting device into control mode, If you do not do any operation within 1 minutest, it
will auto off control mode.
# n
Control channel number (Channel No)
，
n = 1-8
，
Without input parameter: Display current setting
SET n
Setting this device number, n = 0-32, 0 mean stand alone mode (Factory Default)
Do not repeat setting the device number, recommend setting an individual connection to
RS485, not to connect other devices in series in order to avoid any confusion at the setting
number.
STATUS n
Display the current control device channel status
n = 0 display all channel status
n = 1-8 display the specified channel status
Without input parameter: Display current control channel status
AUTO
Setting auto gain mode (Factory Default)
MANUAL Setting manual Equalization mode.
LENGTH n
Manual setting Equalization mode for different cable distance (Sharpness), n = 0-63 (Factory
Default is 0)
，
1 step equal 25 METERS. Without input parameter: Display current setting.
GAIN n
Manual setting Equalization mode for different gain control (Brightness), n = 0-63 (Factory
Default is 32), 0 is the darkest value
，
63 is the brightness value. Without input parameter:
Termination
Resistors
32