6
User Manual
DKM01
4.3
Remove the power jack and plug it in again.
5
EDID Copy
Based on your requirement, you can set up EDID from either TX or RX.
5.1
Remove all the DVI cables.
5.2
Set up the DIP switch of Tx.
5.3
Press EDID Button of the DKM01T to confirm the change.
5.4
You can also set up EDID from RX (DKM01R) to copy the resolution of connected
monitor from RX side as below.
Step 1
Press
“
MENU
”
button from RX to select EDID.
Step 2
Press
“
Select
”
button from RX to confirm the change.
Trouble Shooting
1.
We strongly recommend using high quality CAT5e, CAT6 UTP/STP/FTP cable. Improper
installation may cause unstable connection, and video & audio interruption.
2.
DKM01 transmission data rate up to 850Mbps Max.
3.
Do not connect general LAN to avoid data transmission slow down other LAN devices.
。
4.
Analog audio of Rx (MIC IN) is mono sound for microphone use only, not stereo audio (Line
in)
5.
Every port of USB at receiver side has max output power at 500mA, and 4 ports of USB can
SWITCH
EDID Mode / Settings
SW4
1080p
(Default)
OFF
↑
Copy
the resolution
from Rx side
ON
↓
Copy
the resolution
from TX loop out side
OFF
↑
SW5
OFF
↑
OFF
↑
ON
↓
(Up to 32 pairs of Tx and Rx can be set)
