You have chosen a product from one of Europe's leading manufacturers of wood-burning stoves. We are convinced that
your stove will be to your full satisfaction and give you many hours of pleasure if you follow the advice and instructions of
this manual.
Please read this manual as well as the General Instructions for Installation before beginning the installation.
Congratulations on your new SCAN stove!
Ceramic smoke deflectors
1
Ashtray.
When you open the door, you have access to
the ashtray, which is placed below the combustion cham-
ber.
Attention! Be careful when you empty ashes from the
stove. There may be embers left for up to 24 hours after
the stove was last used.
2
Handle for shaking grate.
The stove is equipped with a
shaking grate. When you activate the grate handle, the
ashes from the combustion chamber are emptied into the
ashtray.
3
Regulation for primary air.
Pull out the handle in order
to open. The primary air is used when lighting and
refuelling the stove. It should always be closed during
continuous firing.
Air for lighting of the stove.
Tilt down and pull out the
handle for extra air when lighting the stove and when
refuelling.
It should always be closed during conti-
nuous firing.
Clean combustion
The SCAN Andersen 10 uses the "CB technique"
(Clean-Burn) to ensure an optimally clean combu-
stion. The extra combustion air is preheated and led
into the combustion chamber close to the ceramic
smoke deflector.
Ceramic smoke deflectors
Lift up the lower ceramic smoke deflector, pull out the
pins in the lateral combustion chamber plates and
remove the deflector. The upper deflector is removed
in the same way.
SCAN Andersen 10
1
3
2
3a
3a
The shaking grate and primary air should always be clo-
sed during continuous firing.
