AccuPro-5000
™
MEASUREMENT SYSTEM OPERATOR MANUAL
Issued by Department:
Engineering
Doc. Number:
5000-00-00-002
Revision:
02
Effective Date:
10/05/2021
File: 5000-00-00-002-r2_
AccuPro_5000_Operator_Manual
Copyright© 2021 Scaletron Industries, Ltd
All Rights Reserved
Page
12
of
63
3.1
Factory Configuration
Before you begin, please notice the configuration sheet that is supplied with this manual. The sheet lists
the factory-programmed parameters for the AccuPro-5000
™
based on ordering information. If there
is a need to change any parameters, please reference this manual for options and instructions on how
to proceed. Both system and channel-level configuration menus must be properly set for correct
operation. Any changes in the measurement units, number of decimal places, value averaging,
setpoints, and calibration will affect the measurement performance and system output! Please record
any configuration changes made before contacting customer assistance for technical help.
3.2
Control-Panel Preparation and Mounting
The Control-Panel is shipped with a factory-installed power cord which utilizes a liquid-tight fitting. Do
not modify nor restrict the ability to disconnect the power cord from an outlet. All other user
connections to the Control-Panel must be made in the field per specific needs.
With power to the Control-Panel OFF, access its interior by following the procedure described in section
titled
. Take time to identify the optimal location for all additional fittings
or conduit. Be careful when drilling holes to avoid any damage to internal components or cabling. All
drilled holes MUST be sealed to prevent both liquids and gasses from penetrating the enclosure and
damaging the electronics. Avoid using fittings that do not provide a tight seal. It is recommended that
all fittings be liquid-tight and 4X NEMA rated. If there is a gap or opening in the
enclosure’s wall
that
isn’t sealed by the connector
design, use a silicon caulk to seal the opening and eliminate exposure.
The Control-Panel is intended to be mounted to a wall using the four holes in the corner flanges of the
enclosure. It should be mounted at operational level and away from the floor. Though the enclosure is
4X NEMA rated, it is not designed to withstand wash-down procedures nor chemical contact beyond
accidental exposure. Avoid direct contact with chemicals or regular soaking of water as it may cause
substantial damage to the electronics. Any damage resulting from non-adherence to these requirements
will not be considered for warranty repair.
It is imperative that you read the instructions in this manual. The Control-Panel
is fully tested and programmed to the corresponding Scale-Base at the factory.
If you experience a problem with this equipment, please disconnect all
accessories to this equipment to isolate the problem. Scaletron has taken great
care to be sure the equipment is fully functional within factory specifications
before it leaves our facility. It is best to familiarize yourself with this manual
for set-up and operation procedures before you begin using this equipment. All
safety precautions need to be observed for its safe operation. Failure to
operate this equipment as instructed can result in damage to the equipment,
and can possibly cause injury. Damage caused to equipment due to improper
operation will not be considered for warranty coverage.
IMPORTANT:
