MOUNTING THE POWER UNIT
HOLES FOR MOUNTING
INSTALLING THE SIGNAL CABLE
Bottom of unit in detail.
This is where the power supply gets plugged in and the signal cable
wires are inserted.
Make sure the two bare wires do not short out by touching each other.
The unit must be mounted indoors in an upright vertical position on a wall or other
non-enclosed area. The picture below shows the location of the mounting holes. The
installer must supply the mounting screws for the type of surface the unit will be
mounted on. (We recommended a number 8 screw.)
TO COIL
TO COIL
5VDC@3A
Terminal Block
Terminal Block Holes
To get wire into terminal block holes, twist
bare cable and insert into one of the
terminal block holes fully then gently
tug wire to insure the wire is locked into
place.
Release Button (button below the wire
holes)
To remove the wire, push the button below
the wire (with finger or small screw
driver) and pull the wire out of the hole.
Not the wire holes.
Do not put wire in
these holes below the release buttons.
5
signal cable wires
Illustration B
Illustration A
connector end of the
AC power adaptor
