- Change measuring rate by measuring mode
The measuring mode can be left by pressing
ESC
. After pressing
ESC
again, the GM 80 will be in menu 1
MEASUR. From there the menu 2 SYSTEM – 2.4 Rate can be called.Select RATE by key
PLUS
and/or
MINUS
. By
pressing key
ENTER
the set measuring rate is being displayed first.By key
PLUS
and/or
MINUS
a new measuring
rate can be adjusted. By
ENTER
the new measuring rate will be taken over, by
ESC
the new measuring rate will be
discarded.
- Switch off GM 80 TG
If the GM80 TG is operating in menu 1 MEASURE it can be switched off, when
ESC
is pressed for >3 seconds.
- Switch off GM 80 PA
This device can only be switched off by disconnecting from current supply.
Measuring with the GM 80:
Selected Sensor
:
Force sensor with measuring range:
200KN
Sensitivity
2mV/V
Designation
e.g.: Press
Parameter set: Sensor no.:
3
Option:
100%
Calibration
control
In order to be able to now measure with this sensor, the sensor " Press" is selected in the measuring mode. During a
measurement, a minimum and maximum value buffer can be called with the
MINUS
key. The respective displayed minimum
or maximum value can be deleted by
ENTER
.
If the measured value shall be sent through an interface to a pc or printer, the baud rate must be adjusted to the receiver
and at SCI-MODE the operating mode must be chosen. For example: HAND, a measured value with time is displayed
during every keystroke on
ENTER
while measuring.
For data logging, adjust operating mode in the logger mode, e.g. choose AUTO and interval time e.g. 10 sec and change to
measuring mode. A measured value with time is now stored every 10 sec. In mode LOGGSEND, these data can then be
sent through the interface.
Key Assignment:
Key Measuring
Mode:
Press = TARE
MEASURING---MIN---MAX--- MEASURING...
ENTER
At MEASURING: send data
At LOGG: store measured value, if adjusted
At MIN: delete MIN At MAX: delete MAX
ESC
Back to menu / Press for 3 sec. = Off
Parameters of a Sensor:
After entering the password (9373) in menu 2SYSTEM-2.5PASS, the sensor can be installed in the calibration menu.
Following parameters are possible:
Sensor__l
Sensor no. 3
Sensor 0 – 9 possible
POINTDIS
200,0
Match meas. range and decimal point (max. 9999)
UNIT
_kN
1 – 3 digit unit possible
DESIGN
Press
Up to 8 digit name (or numbers) arbitrary
CALIB
PAS_wCON
Select
Passive
with cal. control. See data sheet of
sensor
0% LOAD
Unload sensor
0% value of sensor is assigned to display 0
100% CON
Autom. calibration
100% value of sensor is assigned to display
200,0 kN
SAVE
ENTER or ESC
Confirm or discard
