Scag Power Equipment Turf Tiger STT52V-26CH-EFI, Руководство оператора

Страница: 34 / 93

28
R
Section 6
390S0174-1
JAM NUT
ADJUST HERE
Cutter Deck Level Adjustment Figure 6-6.
Using a wrench on the jam nut turn the adjusting 2.
rods until the proper pitch is obtained on both the RH
and the LH side of the cutter deck. Tighten both jam
nuts. See Figure 6-6.
- NOTe -
To prevent the cutter deck from teetering, all four
(4) cutter deck hanging chains must have tension
on them. If all four chains do not have tension on
them and the deck teeters, you must readjust the
cutter deck as outlined in the procedures above.
All measurements should be taken from the top
edge of the deck as the Velocity Plus decks have
an uneven bottom edge.
CUTTER DECK HEIGHT
The cutter deck height adjustment is made to ensure that
the cutter deck is cutting at the height indicated on the
cutting height index gauge. To check for proper deck height,
be sure that the mower is on a flat, level surface and the
tires are properly inflated.
Place the cutter deck in the transport position. 1.
Loosen the jam nuts on both ends of the deck height
control rod. See Figure 6-7.
390S014A-2
CUTTING
HEIGHT
6
5.5
5
4.5
4
3.5
3
2.5
2
1.5
1 48
15
43
HEIGHT ADJUSTMENT PEDAL
LANYARD
PIN
LOOSEN HERE
Cutter Deck Height Adjustment Figure 6-7.
Turn the control rod (See Figure 6-7) until there is a 2.
1/4" space between the rear deck stop and the top of
the cutter deck. See Figure 6-8. Tighten the jam nuts
on the control rod.
1/4"
DECK
STOP
390S0175-1
Cutter Deck Stop Figure 6-8.
Check the cutter deck cutting height by placing the 3.
lanyard pin in the 3" position on the cutting height
index. Release the deck from the transport position
and allow the deck to move to the 3" cutting height
position.
Check the measurement from the floor to the 4.
cutter blade tip. If the measurement is not at 3",
an adjustment can be made using the deck height
control rod. See Figure 6-7.
- NOTe -
If an adjustment had to be made, be sure that the
cutter deck can easily be locked into the transport
position.