26
R
Section 6
Check the cutter deck cutting height by placing the
3.
lanyard pin in the 3" position on the cutting height
index. Release the deck from the transport position
and allow the deck to move to the 3" cutting height
position.
Check the measurement from the floor to the
4.
cutter blade tip. If the measurement is not at 3",
an adjustment can be made using the deck height
control rod. See Figure 6-6.
- Note -
If an adjustment had to be made, be sure that the
cutter deck can easily be locked into the transport
position.
CUSTOM-CUT BAFFLE ADJUSTMENT
6.7
The Custom-Cut Baffle is designed to deliver optimum
airflow and superior cutting performance in any type of
grass. The Custom-Cut Baffle can be raised or lowered
to precisely tailor the deck's performance for the type of
grass being cut. The baffle can be set in seven (7) different
positions for optimum performance.
A. 3-1/2" or 3-3/4" Position - (See Figure 6-9). For very
tall, wiry or tough-to-cut grass.
B. 4" (factory setting), 4-1/4" or 4-1/2" Position - (See
Figure 6-9). For general purpose cutting. This gives the
best mix of cutting performance in all types of grass.
C. 4-3/4" or 5-1/4" Position - (See Figure 6-9). Placing
the baffle in either the 4-3/4" or 5-1/4" setting will
enhance fall cutting (leaf pickup) and reduce cutter
deck "blowout".
To adjust the Custom-Cut Baffle height:
Place the cutter deck in the transport position.
1.
Remove the hardware securing the Custom-Cut
2.
Baffle to the cutter deck.
- Note -
Hardware location used in the illustrations are for
reference only. Location of hardware may vary
depending on cutter deck size.
Move the Custom-Cut Baffle to desired position. See
3.
Figure 6-9.
Reinstall the mounting hardware. Torque hardware to
4.
39 ft-lbs.
1 2
34
A
B
1 2
3 4
A
B
Custom-Cut Baffle Adjustment
Mounting Slot Selected
Mounting Hardware Location
Slot “A”
Hole 1
Hole 2
Hole 3
Hole 4
Height (inches)
3-3/4”
4-1/4”
4-3/4”
5-1/4”
Slot “B”
Hole 2
Hole 3
Hole 4
Height (inches)
3-1/2”
4”
4-1/2”
7-Position Custom-Cut Baffle Adjustment
Figure 6-9.
Содержание STC48V-23CV
Страница 53: ...49 R Section 8 NOTES ...
Страница 56: ...52 R Section 8 ENGINE ATTACHING PARTS 2008 STC EAPBS 1 11 5 2 4 4 3 15 8 12 7 9 14 13 4 10 6 16 4 17 ...
Страница 63: ...59 R Section 8 NOTES ...
