SCA 4.3” WIRELESS REVERSING CAMERA
INSTRUCTION MANUAL
This wireless reversing camera system can be installed without the need to run wires
through the vehicles passenger compartment, which can be difficult for some DIY
installers. As the video signal is sent wirelessly, the time and difficulty of the
installation is greatly reduced.
Installation
Monitor:
Find a suitable location for the monitor ensuring that your vision is not obstructed in
any way. Connect the red wire to a 12V power source (+) and the black wire to a
negative.
Camera:
At the rear of the car locate a suitable mounting location for the butterfly camera
ensuring that it is located as close to the center of the vehicle as possible and attach
using screws. When mounting the camera, make sure the camera does not cover
any part of the license plate. With the license plate removed, check if there are any
pre-‐existing holes through which the cables from the camera can be passed through
to the boot of the vehicle. Run the cables through the hole and re-‐attached the
license plate.
1
