background image

Page 2

PREPARATION

Ensure that all parts are present before assembling your 

2 in 1 Convertible Garage Creeper and

Seat

. Do not attempt to assemble or use the product if any parts are missing or damaged.

Figure 1

14

3
1
1
4

4
6
4

Foam Padded Creeper Section

Open End Wrench

Hex Key

Description

Qty

M8 Hex Head Bolt (60mm)
M8 Flat Washer
M8 Hex Nut
360° Swivel Castor Wheel (50mm)
Castor Wheel Fastener

1
2
3
4
5
6
7
8

Part

4. 

Middle & Rear Wheels:

 Insert one Castor Wheel Fastener (8) into the top of the frame, then

place one M8 Flat Washer (5) through the Castor Wheel (7) and screw in from underneath the
frame. Repeat for remaining three middle and rear wheels (see Figure 2).

5. 

Head Frame Wheels:

 Place one M8 Flat Washer (5) through the Castor Wheel (7). Screw

directly into hole underneath the Head Frame and tighten using Open End Wrench (3).

6. Use Open End Wrench (3) to tighten all Castor Wheels (7) and use Hex Key (2) to tightly secure

all Castor Wheel Fastener (8) assembled in above steps.

7. Do not use or operate the 

2 in 1 Convertible Garage Creeper and Seat

 until all castor wheels

and bolts are tightly secure as injury may occur.

ASSEMBLY INSTRUCTIONS

1. Place the Foam Padded Creeper Sections (1) face down on a flat surface (as shown in

Figure 1), aligning all the outside and inside holes. Ensure the Middle Creeper Section is in the
correct orientation.

2. Place one M8 Flat Washer (5) through the head of the M8 Hex Head Bolt (4), then insert

through the aligned hole, starting from the outside and pushing through the hole.

3. Place one M8 Flat Washer (5) through the head of the aligned bolt and secure with one M8 Hex

Nut (6). Tighten enough that the creeper seat can still fold freely, repeat step 2 and 3 for the
remaining three holes.

Figure 2

Head Frame

Middle Frame

Rear Frame

2 x Wheels (7)

2 x Washers (5)

Front Wheels

4 x Castor
Wheel
Fasteners (8)

4 x Washers (5)

4 x Castor
Wheel (7)

Middle & Rear Wheels

Отзывы: