2.5. IMPORTANT INSTRUCTIONS
Do not open the LiFePO4 battery without consulting the dealer. Unauthorized opening of
the battery voids the manufacturer's warranty.
▪ Only use the battery for the application for which it is intended.
▪ Do not short-circuit the LiFePO4 battery. The cable connections to the consumers
must go through a backup to be protected.
▪ Installation and maintenance may only be carried out by qualified specialists.
▪ Do not expose to permanent direct sunlight. Protect from the effects of
heat. Temperatures above +60 ° C can damage the battery.
▪ Use only compatible chargers. The battery is in a longer storage of all
disconnect devices.
▪ Pay attention to proper assembly.
▪ Avoid damage of any kind, for example by falling, drilling, etc. (Risk of short circuit).
▪ Always keep the battery dry and clean.
▪ Note the plus (+) and minus (-) markings on the LiFePO4 battery and the device and
pay attention to the correct polarity.
▪ The cycle capacity may vary due to the change in the working temperature and
the charge and discharge rate differ from the nominal capacity.
▪ Suitable for parallel connection and series connection and maximum fourbatteries for
12V series batteries and maximum two batteries for 24V series batteries.
Before connecting, bring to the same charge level. Batteries from different
manufacturers or different types should not be interconnected.
3.
INSTALL THE BATTERY
Lithium LiFePo4 batteries are heavy. Make sure it is adequate and safe attach and
always use the appropriate transport equipment. In an accident unsecured, batteries
could become a projectile! Always take carefully with lithium batteries.
Make absolutely sure that the LiFePO4 battery is not connected with reversed polarity.
Should the battery be connected incorrectly, the BMS electronics will be irreparably
damaged and must be replaced with a new BMS board. This is not a warranty case.
The battery model LFP-12V100AHBLH or LFP-12V150AHBLH or LFP-
12V200AHBLH or LFP-12V300AHBLH is acceptable for serial connection, max 4
batteries (48V). The battery model LFP-24V50AHBLH or LFP-24V100AHBLH is
acceptable for serial connections, max 2 batteries (48V). Series or parallel
connections are only for the same standard battery.
Disregard can lead to a defect!
