the device.
•
Disconnect the “Slave” device from the null-modem
connector and set aside. (Keep the power connected
to the Serial3X.)
•
Connect the other Serial3X device to the null-modem
connector and connect the power supply.
•
In HyperTerminal, again push the + key three times
and then push the Enter key.
•
Wait at least 30 seconds. This command prompt
should again appear.
•
Type the following commands. Text listed between <>
indicates instructional text, not the actual text to type
into HyperTerminal. When <Enter> is listed, push the
Enter key on the keyboard. Do not push the Enter key
unless it is specifically stated.
o
a
o
4
o
b
o
<Type the same unique ID name you entered
for the “Slave” device.>
o
<Enter>
o
p
o
<Type the same unique 4 digit PIN you
entered for the “Slave” device.>
o
<Enter>
o
u
o
1152
o
<Enter>
o
0
o
0
o
e
•
This device is now setup as the “Master” device. This
is the device that will connect to the PC.
•
At this point the Serial3X devices will attempt to
communicate with each other. The green LEDs should
both be on solid and the blue LEDs will occasionally
blink. Before about 2 minutes, both devices should
show both the blue and greed LEDs on solid.
•
Remove the “Master” Serial3X device AND the null-
modem adapter from the RS-232 cable.
•
Close HyperTerminal.
31
