Press the other side of the board down into place
gently but firmly until the mounting posts on the GPIO
side of the board click into place in the board's
screw-mounting holes.
Mounting Camera & PIR
Attach the camera module to the top half of the case
using the screws provided to secure it into place
(note: the camera ribbon cable should point toward
the USB holes in the case).
Attach the PIR module to the top half of the case using
the screws provided to secure it into place (note: the
pins should be closest to the camera with the orange
trimming controls aligned with the two holes in the
side of the case).
Connect the camera module ribbon to the Pi. For the
correct method of connection please see this guide
from the Raspberry Pi Foundation
