Saxun ANEAS, Техническое руководство

Страница: 5 / 28

TECHNICAL MANUAL ANEAS 80x40
5
Should any damage and/or a system malfunction be detected, do not continue with the installation.
The manufacturer will not be liable for damage caused during the installation due to non-compliance with these
recommendations.
In order to ensure the safe assembly, use and main-
tenance of this product, a number of precautionary
measures must be taken. Please observe the following
warnings and instructions, for the safety of all con-
cerned.
Please contact your distributor with any queries.
- This manual is intended as a reference for experi-
enced professionals and should therefore not be used
by DIY amateurs or trainee fitters.
- This manual describes the installation of the product
assembly components, and refers to the electrical
control installation manuals. if necessary, this manual
should be supplemented with instructions for any ad-
ditional components not described herein.
-Please read this manual carefully before starting work.
- Some components may be sharp or have jagged edg-
es. It is therefore advisable to wear safety gloves.
- All parts supplied have been designed specifically
for this product. The replacement or addition of oth-
er parts may have a negative effect on the safety of
the product and its warranty. In addition, the CE certi-
fication of this product will become invalid if any parts
are replaced or if the installation is not carried out in
accordance with the instructions in this manual. The
installer shall accept full responsibility in this regard.
- Ensure that the assembly area is sufficiently illumi-
nated. Remove any obstacles or dirt. Make sure no-
body is present besides the fitters. Unauthorised
persons (especially children!) may interfere or cause
hazards during installation.
Before assembly, it is very IMPORTANT for your safety
and that of the product to follow all the recommentions
listed below. A poor-quality installation may cause
harm to people or damage to the installation itself.
Once the product has been unpacked, the professional
fitter has to check its integrity. Before starting the in-
stallation, the arrangement of all components and tools
must be checked in order install the product correctly.
In case of doubt, contact
Giménez Ganga ´stechnical
department.
Under no circumstances should a damaged product be
installed, as it may damage the equipment and create
situations that are dangerous for people.
These systems are exclusively intended for the use for
which they were designed. Any other use is inappropri-
ate, and therefore dangerous.
The system installation must always be performed by a
professional fitter, respecting the manufacturer´s indi-
cations, as well as knowing and applying all the regula-
tions in force.
IMPORTANT
For power operated products , the existing voltage must be checked before
installation.
The connection must always be a grounded connection. Otherwise, do not continue the installation as it may
be dangerous.
1. GENERAL RECOMMENDATIONS REGARDING SAFETY, USE AND
RESTRICTIONS