Thank you for purchasing this light fitting. Please read the instructions carefully before use to ensure safe and
satisfactory operation of this product. Please retain these instructions for future reference.
Warning
This product is Class 2 (Double insulated)
and must not be earthed.
Please read these instructions carefully before
commencing any work.
This unit must be fitted by a competent and qualified
electrician.
Install in accordance with IEE Wiring regulations and
current Building Regulations.
To prevent electrocution switch off at mains supply
before installing or maintaining this fitting. Ensure
other persons cannot restore the electrical supply
without your knowledge. If you are in any doubt,
please consult a qualified electrician.
This light fitting should be connected to a circuit with a
30mA RCD fitted.
If replacing an existing fitting, make a careful note of
the connections.
This product contains non-replaceable parts and
cannot be serviced. If damage occurs the part should
be scrapped.
Waste electrical products should not be disposed of
with household waste. Please recycle where facilities
exist. Check with your local authority or retailer for
recycling advice.
This product is rated at IP44.
The entire unit gets hot whilst on for a period of time.
Specification
Voltage:
240V 50Hz a.c.
Lamp:
7W LED module (SMD 5630) Natural White
IP rating:
44
Layout
• Plan the desired layout of this fitting carefully,
ensuring the cables will reach the distance between
the junction box and the light fitting.
• Avoid locating any cables in positions that would
cause a hazard. Position cables and outdoor rated
junction boxes (not supplied) away from areas
where they may be at risk from being cut, trapped or
damaged.
• We recommend that you use H05RN-F specification
cable (not supplied) which is an outdoor grade,
rubber sheathed cable. The mains supply cable must
have a minimum cross sectional area of 1.0mm²
• Cables must be protected using suitable conduit or
plastic trunking.
Existing fittings must be completely removed before
installation of a new product. Before removing the
existing fitting, carefully note the position of each set
of wires.
• The help of an assistant is recommended when
installing this fitting.
• Remove the finials from the front of the product and
lift the light fitting body away from the wall back.
Keep the finials in a safe place for refitting later.
• Using the wall back as a template, mark the position
of the mounting holes. Drill holes and fit supplied
wall plugs (suitable for masonry only - for other
surfaces use appropriate fixings). Feed the incoming
mains supply cable through the grommet entry
hole. Fix the wall back to the wall using the supplied
screws (See Fig. 1).
• Wire as detailed below.
Installation
Fig. 2
Fig. 1
Securing
Screws
Wiring
This product is double insulated and must not be
earthed. If there are any incoming earth cables, they
must be joined together and well insulated with good
quality insulation tape. This is to ensure earth continuity
throughout your property.
Remove the cover from the mains terminals and having
correctly identified the wiring from your existing light
fitting,connect to the quick fit connection block in the
following way:
ive
eutral
