www.saxbylighting.com
Instruction manual
90376
SHIELDPRO CCT
We recommend cleaning with a soft dry cloth. Do not use solvents or abrasive cleaners as these could damage the finish.
For your safety, always switch off the power supply before cleaning.
Care and Safety
Technical data
220-240 V~, 50 Hz
Supply
Voltage:
Bulb
Type:
7W LED SMD CCT, 3000K / 4000K / 6000K
The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole
luminaire shall be replaced.
Having correctly identified the wiring from your existing light fitting, pull the mains wire through the hole and connect to the
quick fit connection block in the following way.
Wiring
You have correctly identified the wires.
The connections are tight.
No loose strands have been left out of the connection block.
Check that...
V2 21/08/2021
EU Manufacturer: 1 Gnarrenburg, 27442
UK Manufacturer: BH17 7BY
Terminations:
Live supply to L = ( Brown or Red )
Earth to
= ( Green / Yellow )
Neutral to N
= ( Blue or Black )
L
L
N
N
The terminal block allows for Loop-in / Loop-out
connection.
INSERT CABLE
L
L
N
N
PUSH DOWN
LIGHT FITTING
SUPPLY
Brown or Red (L)
Live
Neutral
Blue or Black (N)
Brown or Red (L)
Blue or Black (N)
Conformity with all relevant EC Directive requirements.
The power supply is Double Insulated and does not require connection to an Earth circuit.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or local store for recycling advice.
This product is rated at IP65 (Below the ceiling), IP20 (Recessed parts).
IP
65
This product is suitable for dimming.
Conformity with all relevant UKCA Directive requirements.
This product is fire rated to 30, 60, 90 minutes.
90min
60
30
There are three optional colour bezels – 90377 (Satin Nickel), 90378 (Chrome) and 92513 (Matt black). Rotate the fixed bezel
one quarter turn anticlockwise and pull it away from the luminaire. Select a new bezel and rotate it one quarter turn clockwise
back onto the front of the luminaire.
Do not remove the rubber seal from the rear of the luminaire outer rim. Ensure that it is secure and correctly positioned to
maintain the IP65 rating.
