www.saxbylighting.com
Instruction manual
ST5011, 98442
Odyssey Spike
This product is suitable for dimming.
Max. 7W
LED GU10
Fitting/Replacing the bulb: Max. 7W LED GU10
Technical data
220-240V~, 50Hz
Supply
Voltage:
Bulb
Type:
Max. 7W LED GU10 (required)
This product is rated at IP65.
IP
65
Replace Cracked Shade
ST5011
98442
When changing a bulb, always switch off at the mains and allow the bulb to cool before handling.
Dispose of used bulbs
carefully and responsibly. Use a soft cloth to handle bulbs, avoid directly touching the bulbs as this will shorten their life. Do
not exceed the wattage stated or use a different shape bulb from that indicated on the fitting. Check
with your retailer re bulb dimming capability before purchasing replacement bulbs.
1. Unscrew the bezel
2. Remove the old bulb by turning anti-clockwise.
3. Insert new bulb.
4. Replace the bezel ensuring that it is tightly secured.
Conformity with all relevant EC Directive requirements.
Conformity with all relevant UKCA Directive requirements.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or local store for recycling advice.
V6 11/10/2021
EU Manufacturer: 1 Gnarrenburg, 27442
UK Manufacturer: BH17 7BY
This is a Class 1 product and must be earthed.
For your safety, always switch off the power supply before changing lightbulbs, adjusting spotlight heads or cleaning.
Care and Safety
Do not use solvents or abrasive cleaners as these could damage the finish.
For
ST5011
, in normal circumstances, stainless steel is very resistant to corrosion.
It does however require maintenance to preserve the high quality appearance. Wash the product with warm soapy water,
removing all surface deposits. Rinse with clear water and with a soft cloth, wipe dry.
In some cases, surface corrosion may arise after installation. This is normally caused by tiny iron particles left behind after
the brushing process when finishing.
Wash and dry as detailed above. Then with a soft cloth soaked with a protective oil, wipe all over.
Do not clean the units with a pressure washer.
However if the product is subject to extreme environmental conditions such as marine locations, industrial pollution and acid
rain these maintenance procedures should be carried out around four times a year. For severe corrosion, non-abrasive cream
cleaners or proprietary stainless steel cleaners should be used to remove the corrosion. Wash and dry as detailed above.
Then with a soft cloth soaked with a protective oil, wipe all over.
The shade must be replaced immediately should the shade become cracked or damaged. This fitting
must not be used without the shade in place.
