Thank you for purchasing this light fitting. Please read the instructions carefully before use to ensure safe and
satisfactory operation of this product. Please retain these instructions for future reference.
Warning
This light fitting is Class 1 and must be connected to
an Earth circuit
Please read these instructions carefully before
commencing any work.
This unit must be fitted by a competent and qualified
electrician.
Install in accordance with IEE Wiring regulations and
current Building Regulations.
To prevent electrocution switch off at mains supply
before installing or maintaining this fitting. Ensure
other persons cannot restore the electrical supply
without your knowledge. If you are in any doubt,
please consult a qualified electrician.
This light fitting should be connected to a circuit with a
30mA RCD fitted.
If replacing an existing fitting, make a careful note of
the connections.
This system contains non-replaceable parts and
cannot be serviced. If damage occurs the part should
be scrapped.
Waste electrical products should not be disposed of
with household waste. Please recycle where facilities
exist. Check with your local authority or retailer for
recycling advice.
This product is rated at IP23.
This product is suitable for dimming.
This product is not suitable for location in or near a
marine or sea environment.
The entire unit gets hot whilst on for a period of time.
Specification
Voltage:
240V 50Hz
Lamp:
2 x 35W GU10 Halogen
IP rating:
23
Layout
Installation
Having correctly identified the wiring from your existing
light fitting and connect to the connection block inside
the product in the following way:
Wiring
Check that...
•
You have correctly identified the wires.
•
The connections are tight.
•
No loose strands have been left out of the connection
block.
•
Earth wire is correctly fitted to the earth connection.
•
Incoming mains cable is kept away from the heat of
the lamp
•
Grommet is still in place to maintain the IP rating.
• Plan the desired layout of this fitting carefully,
ensuring the cables will reach the distance between
the junction box and the light fitting
• Avoid locating any cables in positions that would
cause a hazard. Position cables and junction boxes
(not supplied) away from areas where they may be
at risk from being cut, trapped or damaged
• Cables in walls must be protected using suitable
conduit or plastic trunking.
• The mains supply cable must have a minimum cross
sectional area of 1.0mm²
Existing fittings must be completely removed before
installation of a new product. Before removing the
existing fitting, carefully note the position of each set
of wires.
• Remove the finials from the front of the product and
lift the light fitting body away from the wall back.
Keep the rubber washers and finials in a safe place
for use later.
• Using the wall back as a template, mark the position
of the mounting holes. Drill holes and fit supplied
wall plugs (suitable for masonry only - for other
surfaces use appropriate fixings). Feed the incoming
mains supply cable through the grommet entry
hole. Fix the wall back to the wall using the supplied
screws.
• Wire as detailed below.
NEUTRAL
EARTH (GREEN/YELLOW)
SWITCHED LIVE
BLUE (N)
GREEN/YELLOW
BROWN (L)
SUPPLY
LIGHT FITTING
Commissioning
• Place the light fitting over the threads of the securing
screws and refit the rubber washers and finials to
secure. Make sure the fitting is correctly oriented in a
vertical direction.
• Fit the bulbs as detailed overleaf
• Replace fuse or circuit breaker and switch on. Your
light is now ready for use.
Securing Screws
