Warning
Please read these instructions carefully before commencing any work.
This unit must be fitted by a competent and qualified electrician.
Check the pack and make sure you have all the parts listed.
Install in accordance with the IEE Wiring regulations and current Building Regulations.
To prevent electrocution switch off at mains supply before installing or maintaining this fitting. Ensure other persons cannot
restore the electrical supply without your knowledge. If you are in any doubt, please consult a qualified electrician.
This light fitting should be connected to a circuit with a 30mA RCD fitted.
If replacing an existing fitting, make a careful note of the connections.
This product contains non-replaceable parts and cannot be serviced. If damage occurs the part should be scrapped.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with
your local authority or retailer for recycling advice.
Thank you for purchasing this light fitting. Please read the instructions carefully before use to ensure safe and satisfactory
operation of this product. Please retain these instructions for future reference.
Layout
Plan the desired layout of these fittings carefully, ensuring the cables will reach the distance between the junction
box and the light fitting.
Avoid locating any cables in positions that would cause a hazard. Position cables and outdoor rated junction boxes
(not supplied) away from areas where they may be at risk from being cut, trapped or damaged.
We recommend that you use H05RN-F specification cable (not supplied) which is an outdoor grade, rubber sheathed cable.
The mains supply cable must have a minimum cross sectional area of 1.0mm
2
Cables must be protected using suitable conduit or plastic trunking.
The products can be wall or ceiling mounted. If wall mounting ensure that the power supply is at the bottom.
Installation
Wiring
This power supply is Double Insulated and does
not require connection to an Earth circuit.
•
Gently pull the casing away from the shade and set aside.
•
Remove the 4 fixing screws and detach the shade. Keep safe for refitting later.
•
Hold the product in place and mark the position of the holes. Ensure the wall is capable of holding the weight of the
product, or if fitting to a ceiling, ensure there is a joist at the point of fixing to support the weight of the product.
•
Knock out the chosen fixing holes.
•
Fix into position. Take care to avoid damaging any concealed wiring and pipes. The correct fixings should be used for
brick, cavity walls or plasterboard.
•
Pierce a hole in the grommet, and pull the cable through.
•
Wire as detailed wiring.
Check that...
• You have correctly identified the wires.
• The connections are tight.
• No loose strands have been left out
of the connection block.
INSERT CABLE
PUSH DOWN
EARTH (TO TERMINATE)
•
This product is double insulated and must not be earthed. If there are any incoming earth cables, they must be
terminated in the spare terminal of the connection block.
•
Having correctly identified the wiring from your existing light fitting, connect to the quick fit connection block in the
following way:
Commissioning
• Ensure that the screws and cable entry points are sealed to maintain the IP rating of the product.
• Refit the shade, ensuring that the seals are correctly located.
• Gently push your chosen casing onto the shade until it clips in place.
• Replace fuse or circuit breaker and switch on. Your light is now ready for use.
Existing fittings must be completely removed before installation of a new product. Before removing the existing fitting,
carefully
note the position of each set of wires.
Note that the switch is turned off before installation.
Ensure that the screws and cable entry points are sealed to maintain the IP rating of the product.
