• Refit the product onto the bracket, taking care to fit
the washers back in the correct position.
• Adjust the cable so it does not get snagged. Ensure
that the cable gland is properly tightened.
• Ensure that the seal is intact and fitted correctly. Refit
the wiring cover and tighten the screw.
• Set the desired angle for the floodlight and tighten the
bolts.
• Replace fuse or circuit breaker and switch on. Your
light is now ready for use.
• When changing a bulb, always switch off at the mains
and allow the bulb to cool before handling. Dispose of
used bulbs carefully. Use a soft cloth to handle bulbs,
avoid directly touching the bulbs as this will shorten
their life.
• Always ensure that you always use the correct
wattage lamp to match the control gear. Use of
incorrect lamp will damage the lamp and the control
gear. The lamp must be fitted in accordance with the
lamp manufactures instructions. Failed lamps must be
replaced immediately otherwise damaged may occur
to the gear and ignitor.
• The Lamps fitted must be suitable for use
with an external ignitor.
PRS250 :
250W E40 SONT or 250W E40 HQIT
PRS400 :
400W E40 SONT or 400W E40 HQIT
Commissioning
Fitting/replacing bulbs
Instruction leaflet
Deluge Floodlight
PRS250, PRS400
www.saxbylighting.com
Live Voltages may be present in this unit even when turned of or when completely disconnected.
For your safety, always switch off the supply before changing lightbulbs, or cleaning.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
Recycling advice
Safety information
Saxby Lighting Ltd. BH23 3PE
We recommend cleaning with a soft damp cloth.
Do not use solvents or abrasive cleaners as these could
damage the finish.
Do not jet wash these to clean.
Iss.1 18122012
This bulb is protected by a glass shade. This part must be replaced immediately should the glass
shade become cracked or damaged. This fitting must not be used without the glass shade in place.
Replace Cracked
Shade
E
250W E40 SONT
250W E40 HQIT
400W E40 SONT
400W E40 HQIT
THE LUMINAIRE SHALL ONLY BE USED COMPLETE WITH ITS PROTECTIVE SHIELD.
