Saxby Lighting 13937, Инструкции

Страница: 3 / 4

You have correctly identified the wires.
The connections are tight.
No loose strands have been left out of the connection block.
Wiring
Check That
Having correctly identified the wiring from your existing light fitting, pull the wire through the hole and connect to
the connection block inside the product in the following way:
NEUTRAL
EARTH (GREEN/YELLOW)
SWITCHED LIVE
BLUE (N)
GREEN/YELLOW
BROWN (L)
SUPPLY
LIGHT FITTING
Existing fittings must be completely removed before installation of a new
product. Before removing the existing fitting, carefully note the position of
each set of wires.
1. Remove the wall back from the product by removing the side fixing screws
and rubber washers.
2. Carefully pierce a small hole in the rubber grommet in the centre of the wall
back to allow the cable to pass through.
3. Ensure the drain hole is at the base of the wall back, and that the correct
orientation is followed. Take care not to trap or damage any concealed wiring.
4. Ensure the wall is capable of holding the weight of the product. Take care to
avoid damaging any concealed wiring and pipes. The correct fixings should be
used for brick, cavity walls or plasterboard.
5. Fix into position. Take care not to trap the supply wire.
Commissioning
Installation
Wall mount
this way
up only
Switch
Drain hole must
be at the bottom
Rectangle Mirror
6. Unpack the shelf supports and glass shelf and set
aside. Locate the fixing holes for the shelf at the
bottom of the mirror.
7. Position one of the shelf supports under the fixing
holes and fit the screw and washer into place. Tighen
with fingers first to avoid cross threading the shelf
support.
8. Fit the second shelf support in the same way. Ensure
that they are facing the right way.
9. Loosen the plastic grub screws and slide the glass
shelf into place. Adjust the position of the shelf
supports so it sits properly.
10. Tighten the fixing screws and washers
11. Ensure that the rubber sealing is in place. Fit the
mirror over the wall back.
12. Refit the rubber washers and side screws.
13. Ensure that it is fitted correctly to stop the ingress
of mositure.
14 . Replace fuse or circuit breaker and switch on. Your
light is now ready for use.
Plastic Grub Screw
Glass Shelf
Shelf Support
Fixing Screw & Washer