Saxby Lighting 13929, Руководство пользователя

Страница: 3 / 4

You have correctly identified the wires.
The connections are tight.
No loose strands have been left out of the connection block.
Installation
Wiring
Check That
Existing fittings must be completely removed
before installation of a new product. Before
removing the existing fitting, carefully note
the position of each set of wires.
1. Using base plate as a template, mark the
fixing holes onto the mounting surface.
2. Drill holes to the necessary size and
depth - taking care not to damage any
concealed pipes or wiring below the
mounting surface.
3. We recommend fitting this product with
screws (A) which are suitable for use
on most surfaces, however alternative
fixings may be required.
4. Push the raw plugs (B) into the mounting
holes as shown.
5. Wire as detailed below.
A
C
B
Having correctly identified the wiring from your
existing light fitting, pull the wire through the hole
and connect to the connection block inside the
product in the following way:
5.
Pull terminal block (D) from inside of tube.
6. Unscrew the 4 screws which attach the black
box to the spacing strip. Open the black box
and pull out the terminal block.
7. Connect Live input wire to brown wire
on product (or terminal on terminal block
marked ‘L’).
8. Connect Neutral input wire to blue wire
on product (or terminal on terminal block
marked ‘N’).
9. Connect Input Earth wire (Green/yellow) to
Earth wire on fitting,
10. Check that you have correctly identified the
supply wires, the connections are tight and
that no loose strands have been left out of the
connection block.
11. Push terminal block back into the black box,
and refit the terminal blcok cover.
Cable wired to product
Terminal block case
Supply cable
Spacing strip
LIVE
wires
NEUTRAL
wires
EARTH
wire
EARTH
wire