Sawyer Manufacturing Company
7799 S. Regency Dr., Tulsa, OK 74131 USA
F
918.834.0318
P
918.834.2550
sawyermfg.com
V1.2
OUT OF ROUND
1.
Mount long bolt
(K, Fig. 2)
and short bolt
(H, Fig. 2)
to Quick Set machine.
Note: Installation is easier if pin assembly is unlatched
Note: Do not mount attachment with 9/16” nuts attached
Tip: Use 9/16” nut drive
2.
Latch pin assembly.
(Fig. 3)
Installation
Operation
Fig. 1
To derive the correct out of round attachment configuration for egged pipe
follow these steps.
1.
A. Engage pin assembly
(B, Fig. 4)
while compressing spring.
(A, Fig. 4)
B. Raise torch arm wheel assembly
(H)
to the highest setting.
C. Tighten wheel adjustment knob.
(C)
2.
A. Cycle the Quick Set machine to the highest point of the pipe.
B. Loosen adjustment knob
(C)
for wheel assembly
(I)
until it touches the pipe.
C. Tighten wheel assembly adjustment knob.
(C)
3.
A. Disengage pin assembly.
(B, Fig. 4)
B. Cycle the Quick Set so that the torch tip reaches the lowest point on the pipe.
C. Set-up the torch to cut from this point.
4.
Torch arm Setup
A
. Adjust torch arm assembly height by loosening the 9/16” nut.
(I)
1. Adjust 9/16” nut
(I)
to desired position.
2. Tighten 9/16” nut
(I)
for desired height.
B
. Bevel angle adjustment.
(J, Fig. 5)
1. Loosen square nut set screw.
(G, Fig. 5)
2. Adjust to desired bevel angle.
(F, Fig. 5)
3. Tighten square nut set screw.
(G, Fig. 5)
Tip: use ½” wrench
C.
Assemble position adjustment.
(E, Fig. 6)
1. Loosen adjustment knob.
(E, Fig. 6)
2. Move assembly to desired position.
3. Tighten adjustment knob.
(E, Fig. 6)
D.
Mounting torch arm.
1. Loosen adjustment knob.
(D, Fig. 7)
2. Install torch to holder.
3. Tighten adjustment knob.
(D, Fig. 7)
*Please refer to the Quick
Set manual for Operation
of Quick Set*
I
Fig. 2
D
E
G
F
K
H
B
A
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
