SawStop tsa-sa48, Руководство по установке

Страница: 12 / 31

10
SLIDING CROSSCUT TABLE INSTALLATION
13. Place the two M8 T-bolts (109) from the Auxiliary Hardware Pack through the holes in the side of the
extension table assembly. Loosely install the flat washers (108) and lock nuts (110) on the T-bolts. Slide the
heads of the T-bolts (109) into the T-slot on the outside edge of the sliding table, and then tighten the nuts
(110) to secure the extension table in place. For most operations, position the extension table so that it is
flush with the front edge of the sliding table top, as shown in Fig.5 .
14. Slide the miter gauge bar (249) into the T-slot on the sliding table top farthest from the blade, as shown in
Fig.6 . For full cutting capacity, the miter gauge bar should be positioned flush with the front edge of the
sliding table. Use a 5mm wrench to turn the reverse-thread fasteners (248) at the front and rear of the miter
gauge bar COUNTERCLOCKWISE to lock the miter gauge bar in place.
Fig. 5
Fig. 6
WITH
EXTENSION WING
INSTALLING WITH THE EXTENSION WING