Place a combination square on the table top and against the left fence face plate (Fig. 34). Use a 6 mm hex key
to adjust the leveling screws (9) as necessary until the face plate is parallel to the vertical edge of the combination
square.
If necessary, you can adjust both of the plastic set screws (9) to ensure the position indicator lenses (12) are close to,
but not touching, the main tube (8) or rulers (11, 12).
Table Clearance:
The final step is to set the spacing between the bottom of each face plate and the table. The face
plates are held in place by a series of screws threaded into nuts embedded in the face plates. The heads of the
screws fit into key-hole slots in the sides of the fence (Fig. 35).
Fig. 34
Fig. 35
Page 15
|
SawStop T-Glide Fence System - Industrial Series II
9
12
12
11
8
