17
RT-LFT/RT-DCB OWNER’S MANUAL
7
8
Pass a wire hose clamp (2.15) over each
end of the dust collection hose (2.14),
and slide one end of the dust collection
hose over the upwardly-extending
projection on the dust port splitter.
Tighten the wire hose clamp on that end
of the dust hose.
Slide the other end of the dust
collection hose onto 2 ½” dust port on
your router table fence, then tighten the
wire hose clamp on that end of the dust
hose. Note that when you mount the
router table in-line on your saw, the dust
collection hose should go over the rear
rail of the saw.
Using a 4” hose (not included) and a
hose clamp (not included), connect the
4” dust port portion of the dust port
splitter to a dust collection system.
Make sure that both ends of the dust
hose are securely connected and tightly
sealed.
ALWAYS TURN THE DUST COLLECTION SYSTEM ON BEFORE STARTING
YOUR ROUTER, AND TURN THE DUST COLLECTION SYSTEM OFF AFTER
STOPPING YOUR ROUTER.
2.15
2.14
