Installation
Install the sauna heater onto the wall with the screw provided in the heater according to the
minimumsafety distances and volumes indicated in table 1 and figure 1
or on the plate of
the heater
The heater can be installed in the wall rece s at the minimum beight of 1900mm
Do not cover the wall behind the heater with
ater als like asbestos or eternit plates
etc because this sort of covering protection could cause too temperature and a risk of burn
Must use qualified materials for the walls and ceiling
,
,
.
------
s
.
------
m
i
,
.
------
.
Guard Rails
Please follow the minimum distances requirements in figure 6 if guardrails are desired around
the heater
.
Connection of Electricity Supply Cable
Only the qualified electrician may conduct the electricity supply connections of the heater
s
cables taking into consideration of current valid electrical safety regulations The connecting
＇
,
.
.
.
cables of the mains supply to the heater must be of
rubber insulated cables or at least
an equivalent see the figures
There are connection ports in the junction box in sauna heater to
connect the indicating lamps outside sauna
see cobbection ports of circuit diagram
in figure
7
The section of the connecting cables is same as the one of the heater The electricity conne
ction box in sauna room must be of a hermetic splashing proof type with a 7mm diameter co
ndensation hole The junction box should not be more than 500mm over the floor
(
).
(
).
.
,
REVE
Sauna stones
Since the sauna stones may be dusty we recommend that they should be rinsed begore being
loaded into the heater container the largest ones should be loaded at the bottom Do not load
the stones too tight so that air can easily move between the stones whereby a good even coo
ling can be got for the heating elements Reload when stones broken or crumbling so that th
ese stones can be got out of the heater before the heating elements get damaged The diamcter
of the stones is usually of 3 8 cm
,
;
.
.
-
.
-
.
Temperature Control
The thermostat can control the temperature in an ideal condition figure3
Sauna heater
can reach o a preset temperature in 30 to 60 minutes depending on the size of sauna room
Thermostat of three phases electricity can fulfill the preservation of a good even comfor
table temperature in sauna room
(
).
.
Power Switch
The power switch is the main power switch of sauna heater
which should be switched off while leaving sauna
.
Ventilation
Good ventilation is a must for the sauna and conrrectly installed ventilation creates
agreeable bathing conditions but yet still save energy For the ventilation to be succe
ssful it is important where the ventilation openings are suited The fresh air intake
should be better situated on the wall near the bottom of the sauna heater The diameter
of air inlet must be at least 6 cm
The exhaust opening should be better situated on the wall opposite to and as for as
possible from the air intake The diameter of the exhaust opening must be twice the
size of the intake The exhaust opening must be situated under the botom of the upper
benches
,
,
.
-
.
.
.
.
.
.
Содержание SCA-30
Страница 4: ......
