background image

 Page 2 

 

10. Obtain the short tube holder and attach it 

to the left hand side of the printer. Slide tubes 

into the holder for placement.

 

 

6. Obtain the foam block, place it on top of the 

cartridges, and close the cartridge cover.  Be 

careful not to pinch the tubes when closing the 

cover.  

7. Obtain the long tube holder and attach it on 

the flat gray area just beneath the buttons on 

the printer.  The end of the tube must be flush 

with the open edge of the printer as  

highlighted. 

Congratulations!  You’ve successfully installed 

a C88/C87/D88 Quick Connect II ink 

system and printer.   

Tips: 
 

• 

Make sure you install Power Driver from the CD that 
came with your Quick Connect II system.  Refer to the 
Power Driver  documentation and video tutorial on how 
to use Power Driver. 

 

• 

Perform a nozzle check from Power Driver.  A few cleanings may be 
necessary to get a good nozzle check. 

 

• 

You may want to remove the printer lid or leave it open at all times. 

 

• 

You may have a little air in your lines but this will clear after a few 
prints. 

 

• 

If you are going to leave your system without using it for several days 
you should clamp your lines with the tube clamps. 

 

• 

Do not raise the ink box higher than the printer. 

8. Slide tubing into the holder for placement.     

11. Unclamp the end of each tube so that you 

are ready for printing.  Press the ink button to 

move the print head back to the ink cartridge 

parked position.  

9. Position the tubing so that the black line on 

it lines up with the edge of the tube holder.

  

Note: This will leave enough slack so that the 

cartridge bay can easily slide from one side of 

the printer to the other without creating tension 

on the tubes.  

 

Отзывы: