Copyright 2019-2021 Savvier Fitness® LLC
Step 1
•
Place the two Leg Assemblies flat on the floor with
the
Acorn Nuts facing outward.
•
With the Leg Assembly still in the folded position.
Place the two identical Cross Rods into the holes
of the Upright Bars, as shown in Fig.1. Secure with
four Acorn Nuts, forming an X between the Upright
Bars. (Hand tighten only) Note the Top Cross Rod
overlaps on top of other Cross Rod as shown.
•
Place the Base Rod between the Leg Assemblies
and into the holes shown in Fig1, Secure with two
Acorn Nuts. (Hand tighten only)
•
Place each Folding Gusset into the holes on the
Base Bar, as shown in Fig.1. Secure with two
Acorn Nuts. Important, Acorn nuts face outward.
(Hand tighten only)
Step 2
•
Holding the Base Leg in place, rotate the Upright
Bars to approximate position. As shown in Fig.2
•
While holding the Upright Tube in place, Rotate
a Folding Gusset upward. Holding the end of
the Folding Gusset, gently flex the end outward.
Aligning the open end of the Folding Gusset and
hole on the Upright Bar. Gently release the Folding
Gusset completely through the Upright Bar hole.
As shown in Fig.2. Repeat on the other side of the
assembly.
•
Place the Straps onto the Gusset Rods. While
holding the unit in place, gently pull outward on a
Gusset Rod and rotate to place the first hole of the
Strap onto the Gusset Rod. Important. Assemble
the Strap with the hook or scratchy side of the
Velcro facing upward. As shown in Fig.2. Do not
wrap the Strap yet.
Step 3
•
Place the Brackets, in the same orientation, onto
the Wooden Ballet Barre, as shown in Fig.3. Place
an Allen head screw through the Bracket and into
the threaded insert on the Wooden Barre. Repeat
on the opposite side. (Hand tighten only)
•
Place the Wooden Barre with assembled Brackets
into the open top of the Upright Bar.
Noting the
different hole locations.
Gently squeezing the
ends of the Brackets, place the long end of the
Bracket into the Upright Tube on both sides, first.
And then insert the shorter ends of the Brackets to
align with all four holes of the Upright Bar. As shown
in Fig3. Insert four Allen head screws into the holes.
As shown in Fig.3 Detail. (Hand tighten only)
Step 3
FIG.3
Detail
Bracket
Wooden Barre
Folding
Gusset
Step 2
FIG.2
Up Right Bar
Velcro Hook
Fabric- Upward
Strap
Base Leg
Base Rod
Step 1
FIG.1
Leg Assembly
Cross Rods
Gusset Rods
Acorn Nuts
Remove
Cross Rods & Base Rod
Top Cross Rod