8
9. ATTACHING THE FAN
BLADES
Caution:
Remove 5 rubber packing
mounts and discard before installation.
Step 1.
Attach the blade to the blade
bracket using the screws and fiber washers
as shown in Figure 17. Start screw into
bracket. Repeat for the two remaining
screws.
Step 2.
Tighten each screw. Make sure the
blade is straight.
Step 3.
Fasten blade assembly to motor
using the screws supplied. (Fig. 17)
Figure 17
Figure 18
10. INSTALLING THE LIGHT
KIT
NOTE:
Before starting installation,
disconnect the power by turning off the
circuit breaker or removing the fuse at fuse
box.
Step 1.
Raise and hold the light kit close to
the mounting plate and proceed to do the
wire connections. Make the polarized plug
connections:
-White to white
-Blue to black
Step 2.
Carefully push all wires back into
the switch housing. Attach the light kit
fitter by aligning its keyhole slots with the
three screws holes and reversing switch on
the side of switch housing. Tighten the
three screws securely to prevent the light
kit from vibrating loose. (Fig. 18)
Wire connectors
Switch housing
Light kit
assembly
Screws
Screws
Blade
Blades bracket
Screws
Fiber
washers
