8
Figure 16
11. INSTALLING THE
SWITCH HOUSING
NOTE:
Before starting installation,
disconnect the power by turning off the
circuit breaker or removing the fuse at fuse
box. Turning power off using the fan switch
is not sufficient to prevent electric shock.
1. Remove the screws from the mounting
plate under the fan motor.
2. While holding the switch housing under
y o u r f a n , s n a p t o g e t h e r t h e w i r e
connection plug. (Figure 16)
3. Raise the switch housing to the
mounting plate until the holes in switch
housing and mounting plate line up.
Reinsert screws to secure in place. (Figure
16)
12. OPERATING YOUR FAN
NOTE:
Wait for fan to stop before changing
the setting of the slide switch.
Turn on the power and check the
operation of your fan. The pull chain
controls the fan speed as follows: 1 pulls-
High, 2 pulls-Medium, 3 pulls- Low, and 4
pulls-Off.
Speed settings for warm or cool weather
depend on factors such as the room size,
ceiling height, number of fans and so on.
The slide switch controls directions:
forward (switch left) or reverse (switch
right)
Warm weather - (Forward) A downward
airflow creates a cooling effect as shown
in Fig. 17. This allows you to set your air
conditioner on a warmer setting without
affecting your comfort.
Cool weather - (Reverse) An upward
airflow moves warm air off the ceiling
area as shown in Fig. 18. This allows you to
set your heating unit on a cooler setting
without affecting your comfort.
Mounting plate
Connection plug
Screws
Switch housing
Figure 17
Figure 18
