The S
AV
i
O
Compact Skimmerfilter
™
provides skimming action for ponds up to 300 sq. ft. The
Compact Skimmerfilter
™
comes with two biological filtration pads and has the built-in capacity
for one integral UVinex. UVs help create optimal water quality and are available for purchase
separately.
UV filtration
(optional)
eliminates green water
bio-filtration
supports biological health, provides
mechanical filtration and polishes
macro filtration
traps large debris and protects the pump
skimmer filtration
removes up to 85% of debris before it sinks
Important Safety Instructions
Locate a GFCI (ground fault current interrupter) protected power source nearby. Typically a 4 outlet, 15 amp,
110v, grounded, single phase service is sufficient. Refer to your electrical equipment specifications or consult
a qualified electrician to determine power demands for your system.
WARNINGS
To prevent electrical shock disconnect all electrical devices including the UVinex before
servicing the Skimmerfilter.
™
Do not attempt to operate electrical devices with damaged cords or plugs.
Do not attempt to remove any electrical device from the Skimmerfilter
™
by pulling on its cord.
Units with UVinex: UV light throws off radiation that can be harmful to skin and eyes. Always
unplug all power to the Skimmerfilter
™
prior to servicing the UVinex unit. Never look at or touch a
UV bulb during operation.
Operating Capacities
Troubleshooting
Pump chamber runs
dry during operation.
Add water to pond. Water level should be between 3/4” above
or below optimum water mark on faceplate.
Ensure free movement of weir door/ remove obstruction.
Reduce pump flow.
Install smaller pump.
Install larger weir assembly.
Low water level in pond.
Weir door closed/stuck/
obstructed.
Weir not large enough for
pump flow.
Faults
Possible Causes
Remedies
Water leak
around faceplate.
Use #3 phillips screwdriver to hand tighten screws snugly.
Remove weir face, clean liner of mud or gravel, smooth
wrinkles. Reinstall.
Faceplate screws not tight.
Faceplate not sealed properly.
Filter pad requires
frequent cleaning.
Adjust pump flow rate to below recommended maximum.
Remove filter pad. Add a S
AV
i
O
Livingponds
™
filter.
Pump flow rate too high.
Heavy waste load in pond due
to fish or plant debris.
No skimming action.
Ensure free movement of weir door/ remove obstruction.
Check operation of the pump and pump screen (if equipped).
Weir door closed/stuck/
obstructed.
Pump is not functioning.
Replacement parts for Compact Skimmerfilter
™
Code Item
RC001
Screw Packet
RC002
Replacement Filter Mat
RC003
Tank
RC004
Lid
RC005
Basket
RC006
Baffle Front
RC007
Filter Frame Front
RC008
Filter Frame Rear
RC009
Weir Divider
Code Item
RC010
Baffle Rear
RC011
Baffle Top
RC012
8.5” Faceplate
RC013
6” Faceplate
RC014
8.5” Faceplate Seal
RC015
6” Faceplate Seal
RC016
Basket Handle
RC017
8.5” Weir Door
RC018
6” Weir Door