Savin C2410, Справочное руководство

Страница: 20 / 160

Getting Started
14
1
Setting Paper on the Bypass Tray
This section gives instructions for set-
ting paper on the bypass tray. Use the
bypass tray to print onto OHP trans-
parencies, labels, thick paper, and en-
velopes that cannot be loaded in the
paper tray.
Reference
For details about setting paper in
the regular paper tray, see
General
Settings Guide .
Note
❒
When loading letterhead paper,
pay attention to its orientation. See
“Orientation-Fixed Paper or Two-
Sided Paper”,
General Settings
Guide .
❒
Paper within the following dimen-
sions can be set in the bypass tray:
• Vertical: 90 - 297 mm (3.55 - 11.69
in.)
• Horizontal: 148 - 432 mm (5.83 -
17.00 in.)
❒
Be sure to set the paper with the
side you want to print facing down
in the bypass tray.
❒
When loading OHP transparencies
or thick paper in the bypass tray,
make the paper setting using the
control panel or printer driver.
❒
The number of sheets that can be
loaded in the bypass tray depends
on the paper type.
❒
Paper sizes fed from the bypass
tray are output first sheet down,
print side-up.
Limitation
❒
The following functions are disa-
bled when printing from the by-
pass tray:
• Duplex printing
• Auto Tray Select
• Auto Tray Switching
• Rotating Collate
• Staple (when the optional unit is
installed)
Important
❒
When printing using the printer
function, original images are al-
ways rotated by 180 degrees (the
orientation of images to be printed
is opposite to that of the copier
function). When printing onto pa-
per with specific orientation re-
quirements, such as envelopes and
letterheads, make sure to rotate the
paper feed orientation to 180 de-
grees.
AAAA
Open the bypass tray.
BBBB
Adjust the paper guides to the pa-
per size.
Important
❒
If the paper guides are not flush
against the paper, skewing and
misfeeds might occur.
AGP004S
ThemisC1EN-Print-F3_FM.book Page 14 Friday, December 24, 2004 1:20 PM