Savi RFR-100, Руководство по установке

Страница: 22 / 44

3K\VLFDO&RQQHFWLRQV
6DYL5)5HOD\5)5DQG5)5,QVWDOODWLRQ*XLGH
&RQQHFWLQJWKH1HWZRUN&DEOHV
Two network cables connect a Savi RF Relay to a SaviReader
or to a host computer through a network data cable.
&RQQHFWLQJWKH1HWZRUN&DEOHV
WR WKH5) 5HOD\
Note: You will use the same Savi-supplied network cables
whether you are installing a SaviNet or a LonWorks
network configuration (unless you are connecting to
a host computer).
» To connect the network cables:
1. While aligning the notch, plug the cable’s female connector
into the NETWORK IN port on the RF Relay.
(See Figure 2-5 on page 2-8.)
2. Push the locking ring forward and rotate it clockwise until
you feel resistance. Then rotate the connector slightly further
until you distinctly feel it “click” into place as it locks.
3. Connect the other end of the cable either to a SaviReader
in a serial configuration or to a host computer.
If you are connecting to a computer, make sure you are using
the proper adapter cable.
If the RF Relay is installed between two readers in a wired network,
use the NETWORK OUT port to connect to the second reader.