background image

USAI RECESS PINHOLE

SERVICE INSTRUCTIONS

                        CAUTION READ BEFORE INSTALLATION

• Retain these instructions for future reference. This product must be installed by a person familiar with the 
   construction and operation of the product and the hazards involved, in accordance with applicable NEC code.
• Switch off main power before beginning installation.
• Install per national installation and accident prevention regulations.
• Clearance between sides of luminaire and parts of building to be 1/2 inch minimum; clearance to insulating 
   materials to be 3 inch minimum, unless luminaire is IC rated.
• Fixtures must be installed in applications where the ambient temperature does not exceed 40o C during 
   normal operation.
• DO NOT connect or disconnect LED board wire connector when the fi xture is energized. This may result in 
   permanent damage to the LED array.

• Warranty claims will not be accepted if incorrect driver or light engine is used.

Page 1

DRIVER REPLACEMENT:

Caution: Power Must Be Off!!

1. Remove trim.
2. Unplug Quick-Connector.
3. Remove driver plate by pulling towards opening

Driver Plate

4. Rotate driver plate.

5. Remove driver plate thru opening.
6. Unplug Quick-Connectors
7. Replace driver plate.
8. Install in reverse order.

Remove thru 

opening

Driver Plate

© 2018. USAI, LLC.
All rights reserved. 
All designs protected by copyright.
Covered by US Patents. Patents pending.
I2-482

USAI

®

 

Lighting

www.savant.com

[email protected]

1-877-SAVANT5

(1-877-728-2685)

3

4

5

Содержание USAI

Страница 1: ...ns where the ambient temperature does not exceed 40o C during normal operation DO NOT connect or disconnect LED board wire connector when the fixture is energized This may result in permanent damage to the LED array Warranty claims will not be accepted if incorrect driver or light engine is used Page 1 DRIVER REPLACEMENT Caution Power Must Be Off 1 Remove trim 2 Unplug Quick Connector 3 Remove dri...

Страница 2: ...REPLACEMENT FOR DOWNLIGHT Caution Power Must Be Off 1 Remove trim from housing 2 Remove thumb screws 2X 3 Remove heatsink assembly 4 Remove reflector by pulling 5 Install reflector by aligning pins to reflector receptacle and pushing into place 6 Install heatsink assembly and secure with thumb screws 2X 7 Make sure reflector is flush with glass 8 Install trim into housing Thumb Screw Thumb Screw H...

Страница 3: ...ill not be accepted if incorrect driver or light engine is used Page 3 OPTIC REPLACEMENT FOR ADJUSTABLE Caution Power Must Be Off 1 Remove trim from housing 2 Loosen thumb screws 2X 3 Remove optic by pulling 4 Install optic by aligning pins to optic holder receptacle and pushing into place 5 Install heatsink assembly and secure with thumb screws 2X 6 Make sure optic is flush with glass 7 Install t...

Страница 4: ...sink assembly and secure with thumb screws 2X 6 Make sure reflector is flush with lens 7 Install trim into housing Thumb Screw Heatsink Assembly Reflector LIGHT ENGINE REPLACEMENT FOR WALL WASH Caution Power Must Be Off 1 Loosen thumb screw 2X 2 Lift and rotate heatsink assembly 3 Remove reflector 4 Remove cover mounting screws 5 Remove cover 6 Disconnect Light Engine 7 Remove Reflector holder mou...

Отзывы: