PAV-AOM8C | 009-1563-03 | 200110
2 of 2
45 Perseverance Way, Hyannis, MA 02601
Copyright 2020 Savant Systems, LLC
Savant.com | 508.683.2500
Rear Panel
H
G
F
E
D
C
B
A
A
Reset
Resets the network settings of the device.
Hold Reset Button for 5 seconds while powered
on to clear network settings. Status LED will
rapidly blink red when reset is complete.
B
USB
USB 2.0 Type A (reserved for future use).
C
GPIO
(2) General Purpose Input/Output.
3-pin Control Connector
See GPIO Wiring for pinouts
GPIO Input
: When configured as an input the
processor will look for a low (<0.8V DC) or a high
(>2.4V DC) state.
Minimum 0V DC / Maximum 12V DC.
GPIO Output
: When configured as an output, the
port provides a binary output of 0-12V
DC 150mA max.
D
RCA Outputs
(8) Analog stereo line output (Left & Right)
Direct Line Level 2.1-V
RMS
Output
E
Ethernet
8-pin RJ-45 port, PoE – 802.3af compliant
10/100/1000 Base-T auto-negotiating port with
Link/Activity LEDs.
Supports Audio Video Bridging (AVB).
F
Ethernet
Activity LED
Green Blinking
: Activity (Rx/Tx).
Off
: No Activity.
G
Ethernet Link
LED
Green Solid
: Ethernet Link is established.
Off
: Ethernet link is not established.
H
Power Input 5V DC 3A
GPIO Wiring
General Purpose Input/Outputs
(GPIO) are binary I/O ports used
on Savant controllers to trigger an
action within the system. Events
can control a device, such as turning
on an amplifier (output) or detecting
a state change for a device (input) to
perform a workflow. Pin 2 is used for
input or output depending on configuration.
GPIO Pull Down Resistor (PD) Usage
GPIO pins are configured as inputs and are pulled high to 12V while the
host is booting up. To make the GPIO signal low during a host reboot
and/or a power cycle, attach the GPIO 1 pin to the PD pin. The PD pin
is a 1K ohm pull down resistor (to signal ground) which keeps the GPIO
output below 0.8V during processor boot times.
Expansion
Savant AVB devices can be connected in a single system. Providing a
virtual audio switch. That can be configured to suit almost any need.
See the
Savant IP Audio Deployment Guide
for more information
maximum number of devices.
Additional Documentation
Refer to the following documents located on the
for additional information.
–
Savant IP Audio Deployment Guide (009-1571-xx)
NOTE:
While not shown this
diagram, GPIO 2 follows the
same wiring as GPIO 1.
3
2
1
Pin 1
Ground
Pin 2
GPIO 1
Pin 3
Pull-Down Jumper 1
G 1
PD1
