HCX-4KHDR40 | 009-1673-02
Copyright 2020 Savant Systems, LLC | 200406
2 of 2
45 Perseverance Way, Hyannis, MA 02601
Savant.com | 508.683.2500
Installation
An HDBaseT extender can be placed on a standard 1U rack shelf, or
can be installed using the included mounting brackets. To install the
mounting brackets, follow the steps below.
1. Remove the two case screws on the side of the device
(Shown in the image below).
2. Align the bracket using the top holes.
NOTE
: This will leave an air gap behind the device.
3. Replace the case screws attaching the bracket.
HDBaseT Cable Information
Category 6 or greater twisted pair cable with RJ-45 connectors
between the transmitter and the receiver is recommended.
TIA/EIA-568B straight-through wiring connections must be used.
Transport Distance (4K)
Cat6
115 ft (35 m)
Cat6a/7
131 ft (40 m)
Transport Distance (1080P)
Cat6
197 ft (60 m)
Cat6a/7
230 ft (70 m)
RJ-45 Connector
(Gold pins facing up)
TIA/EIA-568B
1
2
IR Wiring
IR Control is pass-through only.
IR Emitter
Connect to 3.5 mm IR Out to control a IR device.
3
2
1
Pin 1
IR - (Black)
Pin 2
IR + (Red)
Pin 3
Not Used
IR Connector Cable
Connect to 3.5 mm IR In to pass-through IR control from a Savant
Controller.
IR Receiver
Connect to 3.5 mm IR In to pass-through IR control. Not
commonly used in a Savant Deployment.
RS-232 Wiring
RS-232 control signal pass-through only.
Serial control connections are made using
a 3-pin Control Connector supplied with
the device. The wire slips into the hole
and locks with a screw located at the top
of the connector.
IMPORTANT NOTE!
Use of a crossover
cable between the controller and the Transmitter is required.
Pin 1
Ground
Pin 2
2
Transmit
Pin 3
Receive
1
3