å
Carefully stand your unit upright.
å
Separate the EXTENSION SLIDES (40NC) from the EXTENSION RAILS (40NA) as shown in the upper diagram below. Be
prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (40NA) to the ENDS (A and B). Use four GOLD 5/16" FLAT HEAD SCREWS (3S) through
holes #1 and #4.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagrams. Then, slide the inner cartridge
of the EXTENSION RAIL out to fi nd the other hole that lines up with the hole in the END. Turn a SCREW into this hole.
Step 11
422593
www.sauder.com/services
Page 15
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
3S
A
B
Open end
1
3
2
4
1
3
2
4
Push the black lever in and pull the SLIDE from the RAIL.
40NA
40NC
Open end
